Free Tool · Arc Flash PPE Selection
Arc Flash PPE Category Estimator
Select the task closest to the electrical work being planned to see a general arc-rated PPE category. This is a starting reference only – a documented arc flash risk assessment or incident energy analysis should always determine the exact PPE category for a specific piece of equipment.
De-Energized Equipment, Zero Energy Verified
Where equipment has been properly isolated, locked out and verified de-energized, arc-rated PPE is generally not required for this specific task, though standard electrical safety procedures still apply.
Relevant standards:
Routine Switching on Normal Low-Voltage Equipment
Routine switching operations on normal, well-maintained low-voltage equipment typically fall into the lower arc-rated PPE category, broadly equivalent to an arc rating around 4 cal/cm² under EN 61482-2 Class 1.
Relevant standards:
Exposed Low-Voltage Conductors
Working on or near exposed conductors with panel covers removed typically requires the higher arc-rated PPE category, broadly equivalent to 8 cal/cm² or more under EN 61482-2 Class 2.
Relevant standards:
Medium-Voltage or High Fault-Current Equipment
Work on medium-voltage switchgear or high fault-current low-voltage equipment generally requires a category beyond standard Class 2 and a specific engineering assessment of incident energy before work proceeds.
Relevant standards:
Racking Circuit Breakers Under Load
Racking breakers in or out while energized is treated as a high-risk task requiring full arc-rated PPE including a face shield or hood, regardless of the equipment’s normal operating category.
Relevant standards:
Unknown or Unstudied Fault Current
Where fault current or incident energy has not been formally studied, work should not proceed until an arc flash risk assessment is completed – do not assume a category based on equipment appearance alone.
Relevant standards:
How to Use This Tool
Select the task category closest to the planned work, and treat the result as a general reference point only. Facilities with a documented arc flash study should always follow the specific category assigned to that equipment in the study, which takes precedence over any general guidance here.
Why an Estimator Cannot Replace an Arc Flash Study
Actual incident energy depends on fault current, clearing time, working distance and equipment configuration, all of which are specific to your installation. This tool provides a general planning reference; a qualified engineer should complete or provide a formal arc flash risk assessment for equipment where precise category selection matters.
Frequently Asked Questions
What does an arc-rated PPE category actually mean?
It refers to the minimum arc rating, measured in cal/cm², that a garment or PPE ensemble must provide to protect against the expected incident energy for a given task on specific equipment.
Is arc-rated PPE the same as flame-resistant clothing?
Not necessarily. All arc-rated clothing is flame-resistant, but not all flame-resistant clothing carries a tested arc rating. Only clothing specifically tested and rated under a standard such as EN 61482 should be relied on for arc flash protection.
Does de-energizing equipment always remove the need for PPE?
Only once isolation is verified with a proper test for zero energy using calibrated equipment. Simply switching off is not the same as verified isolation.
Who should carry out an arc flash risk assessment?
A qualified electrical engineer with specific competence in arc flash and incident energy analysis, using the actual fault current and protection device clearing time data for your installation.
Do these categories apply to every electrical installation?
These are general reference bands. Actual required categories vary by installation and should be confirmed by a site-specific arc flash study wherever one exists or is required.
Explore the full EN Standards Library for every standard referenced above, or read real Field Stories showing what happens when selection goes wrong.